Cuprinol Anti-Slip Decking Stain - Silver Birch - 2.5L

It is recommended to apply 2-3 coats for optimal protection and finish. Ensure each coat is dry before applying the next.

No, the existing paint or varnish must be sanded off or chemically stripped before application, treating it as bare wood.

The stain covers approximately 8 m² per litre on average, depending on the surface and application method.

The drying time is between 2 to 6 hours. Avoid heavy wear for a few days after application.

No, Cuprinol Anti-Slip Decking Stain is specifically designed for exterior use only.

Remove as much product as possible from brushes and rollers before cleaning them with water.

Ensure the stain was applied correctly with the recommended number of coats. The anti-slip microbeads improve safety, but very wet conditions can still pose a risk. Consider additional safety measures if extreme slipperiness is a concern.

Ensure thorough stirring before and during use. Apply evenly along the grain, avoiding overlaps. If starting a new can, mix it with the previous one or finish a section before switching.

Check the ambient temperature and humidity. Ensure application was not done below 5°C or in damp conditions. Avoid application if rain is imminent.

Ensure the surface was thoroughly cleaned and treated for algae/mould before application. Apply the recommended number of coats for maximum protection. Reapply as per maintenance guidelines.

Verify that the surface was properly prepared (clean, dry, free from grease/oils). Ensure previous coatings were compatible or removed. Check that the temperature and weather conditions were suitable during application.