Polypipe 110mm Soil 92.5deg Bend Double Socket Black - SB417B

The 92.5° angle allows for precise directional changes in soil and vent pipe runs, facilitating efficient waste flow and odor management, especially in complex or confined installations.

While designed for the Polypipe PolySoil® system, it is compatible with other 110mm uPVC soil and vent pipes when using appropriate push-fit ring seal or solvent weld methods. However, always ensure a secure and watertight fit, as tolerances can vary.

The bend supports both 'push-fit ring seal' for quick, reliable connections, and 'solvent weld' for a permanent, fused bond.

This product is specifically designed for soil and vent systems within a building's structure. For underground drainage, different specifications and products may be required.

A double socket means the fitting has two sockets, allowing it to connect to two separate pipes or fittings at the same junction.

You can use standard drain clearing tools such as a drain snake or a pressure washer. Avoid using harsh chemical drain cleaners that could degrade the uPVC material.

Ensure the pipe is fully inserted into the socket and the ring seal is correctly seated. If using solvent weld, check that the joint was properly bonded. Re-seal or re-join if necessary.

Confirm the pipe is clean and has not been deformed. Lightly lubricate the pipe end and socket entry for push-fit connections. Ensure the pipe is inserted straight.

Verify the 92.5° angle is correctly oriented to promote flow. Check for obstructions within the pipe system upstream of the bend.