Soho Lighting Antique Brass 3 Gang Switch with 1 Dimmer - Bronze

The maximum load for dimmable LED bulbs is 150W.

No, this dimmer is designed specifically for dimmable LED, Halogen, and Incandescent bulbs. Using non-dimmable bulbs may cause damage to the bulbs or the dimmer.

The dimming mode can be switched by following the specific button press sequence indicated in the product manual for the Enkin PDM150 module. This is typically done after installation.

No, the toggle switches function as standard on/off switches and do not require special bulbs. Standard household bulbs are suitable.

Yes, for multi-location switching, you will need to use standard 2-way switches (sold separately) in conjunction with the intelligent dimmer.

Soft-start technology gradually increases the light intensity over 1-2 seconds when turning lights on, which reduces stress on the bulb filaments and helps prolong their lifespan.

Yes, due to the nature of electrical wiring, it is recommended and often required by law that this switch be installed by a qualified electrician.

Ensure you are using dimmable LED bulbs. Check that the total LED load does not exceed 150W. Try switching the dimmer mode from trailing edge to leading edge (or vice-versa) using the setup button.

Verify wiring connections for the toggle switch are secure and correct. Ensure the circuit breaker for that switch is not tripped.

Some humming may occur with certain types of dimmable bulbs, especially at low light levels. Ensure bulb compatibility and check the dimmer mode setting.

Confirm that you are using compatible dimmable bulbs. Ensure the wiring is correct for a 2-way circuit if applicable. Check for any potential short circuits.