Lieber Dimmer and Rocker Switch Combo - White

The dimmer supports a maximum load of 150W for dimmable LED bulbs and 300W for dimmable Halogen/Incandescent bulbs.

No, this dimmer is designed specifically for 'dimmable' LED bulbs. Using non-dimmable bulbs may result in flickering, poor performance, or damage to the dimmer and bulb.

The dimming mode (leading or trailing edge) can be changed using a simple push-button setup on the module. Refer to the installation guide for specific instructions.

You can control the dimmer function from multiple locations by using standard two-way switches wired to the dimmer module. The rocker switch also supports standard two-way switching configurations.

Soft-start technology gradually increases the light output when turned on, reducing stress on the bulb filament or LED components. This helps to prolong the lifespan of your bulbs, especially LEDs.

Installation involves standard electrical wiring. If you are not comfortable with electrical work, it is recommended to hire a qualified electrician.

The switch plate is a classic white, designed to blend seamlessly with most interior decors.

Ensure the connected bulbs are marked as 'dimmable'. Try switching the dimming mode (leading/trailing edge) using the push-button setup. Check that the total load does not exceed the 150W LED or 300W Halogen/Incandescent limit.

Verify the wiring connections for the rocker switch. Ensure the light fixture is functional and the bulb is not burnt out. If used in a multi-location setup, check the wiring of the companion switch.

A slight warmth is normal, especially when dimming high-wattage loads. However, if it becomes excessively hot, immediately turn off the power and check the load against the maximum rating. Ensure proper ventilation around the switch.

Confirm that power is restored to the circuit at the breaker. Double-check all wiring connections to the switch and ensure they are secure.