Block Paving Sealer - Smartseal - 5L 2 Pack

The sealer typically lasts for 2-3 years, depending on traffic and environmental conditions.

No, apply the sealer in dry weather with temperatures between 10°C and 25°C.

Coverage is approximately 2m² per liter for the first coat and 3.5m² per liter for the second coat, but this can vary based on surface porosity. Calculate the area of your paving and use these figures to determine the required volume.

Regular sweeping is sufficient. For spills, use mild detergent and water.

It is suitable for most block paving and flagstones. Always test on a small area first to ensure compatibility.

Avoid applying the sealer if rain is expected within 24 hours. If rain occurs shortly after application, the sealer's performance may be affected.

No, you must remove the existing sealer before applying Smartseal Block Paving Sealer for optimal results.

Ensure the surface was completely dry before application. Allow additional drying time or consider applying a thin additional coat.

Ensure the application rate is correct. Apply a second coat to achieve desired coverage. Porous surfaces may require more product.

Ensure the surface was properly cleaned and prepared before application. Remove the affected sealer and reapply after proper preparation.

The sealer prevents weed growth but cannot kill existing weeds. Remove any weeds before application.