SmartSeal Matt Imprinted Concrete Sealer - 5L

A 5L container covers approximately 20-30 square meters, depending on the porosity of the concrete and the number of coats applied.

Drying times vary depending on weather conditions. Generally, allow 4-6 hours between coats and 24 hours for full cure, but always refer to the product instructions.

No, the concrete surface must be completely dry before applying the sealer to ensure proper adhesion and performance.

It is suitable for most types of imprinted or stamped concrete. Always test in an inconspicuous area first.

Regular sweeping to remove debris and occasional washing with a mild detergent and water is recommended.

Reapplication frequency depends on use and environmental conditions. Inspect the surface annually and reapply when the protective qualities diminish.

Wear appropriate personal protective equipment (PPE), including gloves and eye protection. Work in a well-ventilated area, and avoid inhaling vapors. Keep away from flames.

Ensure the surface is completely clean, dry, and free of any previous sealers or contaminants before application. Apply in the recommended temperature range.

Ensure the concrete surface is clean, dry, and free of any previous sealers or contaminants before application. Make sure the surface is completely dry before using.

This could be due to moisture. Ensure the concrete is completely dry before applying the sealer, and apply in recommended conditions.