Wavin OsmaSoil 110mm Ringseal Single Socket Solvent Weld Bend 45 Degree - 4S363 Grey

The 45-degree angle allows for changes in direction in your soil and waste pipe runs, enabling you to navigate around obstacles or connect to different parts of the drainage system.

No, the Wavin OsmaSoil system, including this bend, is specifically designed for above-ground drainage applications.

One socket is a push-fit ring-seal type, designed for quick and easy connection with a pre-installed seal. The other is a solvent weld socket, requiring primer and cement for a permanent, rigid joint.

Ensure the pipe is pushed fully into the ring-seal socket. The captive seal technology is designed to maintain a watertight seal when properly engaged.

You will need Wavin PVC-U primer and Wavin solvent weld cement, along with a clean cloth, to prepare the surfaces and create a secure bond.

This system is designed for sanitary waste. Its resistance to common chemicals makes it suitable for household and commercial waste, but always consult manufacturer guidelines for specific chemical compatibility.

Ensure the pipe is fully inserted into the ring-seal socket. Check the condition of the captive seal and clean the pipe end. If the seal is damaged, the fitting may need replacement.

Ensure surfaces were properly cleaned and primed before applying solvent weld cement. Check that the cement was still wet when the pipe was inserted and held in place. Re-do the joint if necessary, following manufacturer instructions for primer and cement.

For push-fit, ensure the pipe end is clean and slightly chamfered. A small amount of silicone lubricant can aid insertion. For solvent weld, ensure no excess primer or cement is obstructing the socket.