High Tensile Set Screw - M10 x 70 - Silver - 10 Pack

'High tensile' refers to the steel's increased strength, meaning it can withstand a significantly larger amount of pulling or shearing force before deforming or breaking compared to standard steel screws. This makes them suitable for heavy-duty applications.

Yes, the zinc-plated finish provides good corrosion resistance, making them suitable for many outdoor applications. However, in extremely corrosive environments (e.g., marine or industrial chemical exposure), additional protection or different materials might be required for optimal lifespan.

For an M10 hex head set screw, you will typically need a 17mm wrench or socket.

Info needed: [Specific torque values depend heavily on the material being fastened, the joint type, and the exact application. Always consult relevant engineering standards (e.g., ISO, DIN) or your project's specific torque chart for M10 high-tensile fasteners to ensure proper and safe installation.]

While the term 'set screw' can sometimes refer to headless fasteners, in this context (Forgefix High Tensile Set Screw - M10 x 70), it refers to a hex head fastener that is *fully threaded* along its entire shaft, unlike many standard bolts that have a partially unthreaded shank. This full threading maximizes thread engagement.

Generally, high tensile fasteners can be reused if they have not been subjected to excessive stress, deformation, or significant corrosion. Always inspect them thoroughly for any signs of damage (e.g., stretched threads, bent shaft) before reinstallation, especially in critical applications.

Check the internal thread of the mating component for damage or debris. Ensure you are using the correct M10 thread. Apply a thread lubricant if necessary.

Verify that the correct torque specification was applied. Check for deformation in the materials being joined or if the screw length is too short for full engagement. Ensure compatible nut and washer (if used) are of appropriate grade.

While zinc-plated, extreme environments (e.g., highly saline, acidic) can accelerate corrosion. Ensure proper environmental sealing if possible, or consider additional protective coatings for such conditions.

Ensure you are using the correct size and type of wrench/socket that fits snugly. Avoid using worn tools. Lower the torque setting and tighten more gradually.