Forgefix High Tensile Set Screw - M10 x 100mm - White

High tensile refers to the material's ability to withstand significant pulling force (tension) before breaking. These screws are made from a specially hardened steel, making them much stronger and more durable than standard steel screws for load-bearing applications.

'M10' indicates a metric thread with a nominal diameter of 10 millimeters. '100' refers to the screw's length, which is 100 millimeters from the underside of the head to the tip of the screw.

Yes, the zinc plating provides good corrosion resistance, making them suitable for many outdoor and moderately damp environments. For applications with constant exposure to harsh elements (like saltwater), consider additional protective measures or fasteners with superior corrosion resistance like stainless steel.

You will need an M10 size wrench or socket for tightening. For precision applications or critical joints, a torque wrench is highly recommended to ensure proper tightening without over-stressing the fastener or materials.

While durable, frequent reuse, especially after high torque applications, can potentially wear down the threads or zinc plating. For critical applications, it's generally best practice to use new fasteners to ensure maximum integrity. Inspect used screws carefully for any thread damage or corrosion before reuse.

A fully threaded design means the threads extend along the entire length of the screw shaft. This maximizes the engagement with the mating nut or tapped hole, providing a stronger grip and better load distribution, which is beneficial in applications requiring high tensile strength and resistance to shear forces.

Check if the mating nut or tapped hole is also M10. Ensure threads are clean and not damaged. If tapping a hole, confirm the pilot drill size was correct for M10. Avoid cross-threading by starting the screw straight.

Ensure you are using the correct size and type of wrench/socket for an M10 hex head. Apply steady, even pressure. If the head is already damaged, try using a bolt extractor or cutting a slot for a screwdriver, if accessible.

Verify that the screw is tightened to the correct torque specification. Ensure all components are flush and that appropriate washers (e.g., flat and lock washers) are used to prevent loosening under vibration or load. Check for proper hole sizing; oversized holes can lead to play.

While zinc-plated, severe environments can still cause corrosion. Ensure the installation environment is not overly harsh (e.g., constant saltwater spray). For future installations in such conditions, consider fasteners with superior corrosion resistance (e.g., stainless steel) or additional protective coatings/sealants.