Cuprinol Ducksback 5L - Green

No, Cuprinol Ducksback is specifically formulated for sheds and fences. For garden furniture, you should choose a product designed for that purpose, as it may require different durability or finish properties.

For optimal protection and colour depth, we recommend applying two coats. Always allow sufficient drying time between coats as specified on the product label.

This paint is quick-drying. Touch dry times are usually within 2-4 hours, and recoat times are typically within 6-8 hours, depending on temperature and humidity. Always ensure the first coat is fully dry before applying the second.

Yes, once dry, the formulation is considered safe for use in areas around plants and pets. However, it's always best to keep pets and children away from the treated area until the paint is completely dry.

You don't typically need a separate primer. However, for best results, ensure the surface is clean, dry, and free from any loose, flaking paint or debris. Lightly sanding smooth areas can improve adhesion.

Cuprinol Ducksback provides a decorative, opaque green finish that also acts as a protective barrier against weathering. It enhances the natural look of the wood while providing long-lasting colour.

Coverage can vary depending on the porosity and roughness of the wood. As a general guide, a 5L tin typically covers approximately 30-40 square meters with one coat. Always refer to the product label for specific coverage rates and recommendations.

Ensure the surface was clean and dry before application. Stir the paint thoroughly before and during use. Apply evenly with a brush, following the wood grain. A second coat usually evens out the finish.

Check ambient temperature and humidity. Paint dries best in dry, mild conditions. Avoid applying in cold or damp weather. Ensure coats are not applied too thickly, which can prolong drying time.

For poor coverage, ensure the surface is properly prepared and apply a second coat if necessary. If paint is running or dripping, you are likely applying too much paint at once; use less paint on your brush and apply thinner, more even coats.

This often indicates poor surface preparation. Ensure all loose material, dirt, and previous flaking paint were removed. The surface must be clean, dry, and sound before application. Sanding might be required for better adhesion on very smooth surfaces.

This can sometimes happen if the paint gets wet before it's fully cured or if condensation forms on the surface. Ensure adequate drying time between coats and protect from rain. Allow the area to dry thoroughly; these marks often disappear as the paint fully cures.