Hammerite Special Metal Primer - Red - 250ml

It is suitable for stainless steel and non-ferrous metals like aluminum, galvanized steel, chrome, brass, and copper.

It is touch dry in approximately 30 minutes and can be overcoated after 2 hours.

Yes, this primer is suitable for both indoor and outdoor use.

All surfaces must be clean and dry. Remove loose rust, flaking paint, and gloss from old paintwork by wire brushing or rubbing down with coarse abrasive paper. Treat any rusted patches with Hammerite Kurust. Degrease thoroughly with a detergent solution, then rinse with clean water and allow to dry.

Generally, one coat is sufficient. However, for porous surfaces, two coats may be needed.

Avoid contact with skin and eyes. If contact occurs, rinse thoroughly with water and seek medical advice if irritation persists.

The product's shelf life is not explicitly stated in the provided information.

Ensure the surface has been properly prepared by removing rust, flaking paint, and any contaminants. Lightly sand the surface to promote adhesion. Make sure the surface is clean and dry before priming.

Check the temperature. Do not apply if the temperature is below 5°C or if rain or frost is expected. Ensure adequate ventilation.

If medical advice is needed, have product container or label at hand. Do not get in eyes, on skin, or on clothing.