Forgefix Carriage Bolt & Nut - M10 x 100mm - Bag 10 - White

These coach bolts are primarily used for joining timber to timber in low load-bearing construction projects, such as assembling garden furniture, building pergolas, fixing fence panels, or connecting non-critical timber joists.

Low load bearing means the bolts are designed for applications where they will not be subjected to significant structural weight or high stress. They are suitable for general assembly and decorative purposes, not for main structural components that support heavy loads.

Yes, it is essential to drill a pilot hole through the timber. This prevents the wood from splitting and ensures the bolt can be inserted correctly. The pilot hole size should be slightly larger than the bolt shank but allow the square neck to bite into the wood.

Yes, the zinc-plated finish provides good corrosion resistance, making them suitable for both indoor and sheltered outdoor applications. For prolonged exposure to harsh weather, additional protective measures like paint or sealant over the bolted area can extend their lifespan.

Each pack contains 10 Forgefix Coach Bolts, and each bolt comes complete with its corresponding hex nut.

You will typically need a drill with an appropriate drill bit (e.g., 10.5mm or 11mm for an M10 bolt), a hammer to seat the square neck, and a spanner or wrench. For an M10 hex nut, a 17mm or 16mm spanner is usually required. Info needed: [confirm exact spanner size for M10 hex nut].

While you can use them to attach timber to thin metal brackets, these bolts are primarily designed for securing into timber. The square neck is specifically for preventing rotation in wood, and they are not optimized for metal-to-metal applications.

The square neck of the bolt has not fully seated into the timber. Remove the nut, and gently tap the bolt head with a hammer to ensure the square section bites securely into the wood before retightening.

Check that the nut is aligned correctly with the bolt threads and is not cross-threaded. Ensure there is no debris or paint in the threads of either the bolt or the nut. If the issue persists, the threads may be damaged, and the bolt/nut should be replaced.

The pilot hole may be too small or the timber is too close to an edge. Ensure the pilot hole is appropriately sized for the M10 bolt, allowing for easy insertion without forcing. Consider drilling a slightly larger hole, or if the split is severe, select a new location or reinforce the timber.

Verify the thickness of the timber you are joining and compare it against the bolt's 100mm length. Always measure carefully before purchasing. If the length is incorrect, you will need a different size bolt.