Turtle Beach Afterglow Wave Wireless Controller for Nintendo Switch 2 - White

While officially licensed for Nintendo Switch, the controller's Bluetooth and USB connectivity may allow for use with PC, but functionality and compatibility are not guaranteed and may require additional drivers or software.

Refer to the included user guide for the specific button combination or procedure to cycle through the four preset RGB lighting modes and adjust brightness.

The controller offers up to 20 hours of battery life on a single charge, depending on usage and RGB lighting settings.

The controller features a built-in rechargeable battery that is not designed for user replacement.

Mapping instructions are detailed in the user guide. Typically, it involves holding a specific button combination and then pressing the desired action button and the back button you wish to assign.

Yes, the controller features a 3.5mm headphone jack for audio output and communication.

The dedicated C Button provides quick access to GameChat functions, allowing for easy management of in-game conversations.

The controller provides a wireless range of up to 9 meters (approximately 30 feet) with low latency.

Ensure the controller is charged. Try re-syncing by holding the sync button on the controller and console. Check for interference from other wireless devices. Ensure Bluetooth is enabled on your Switch.

Try cycling through the lighting modes using the dedicated button if available, or consult the user guide for a reset procedure. Ensure the controller is powered on and has sufficient battery.

Verify that motion controls are enabled in the Nintendo Switch system settings and within the game you are playing. Re-calibrate the motion sensors through the Switch's controller settings if necessary.

Re-map the buttons following the instructions in the user guide. Ensure you are pressing the correct button combination for mapping and that the assignment was successful.

Try a different USB Type-C cable and a different USB port on your Switch. Ensure the cable is fully inserted into both the controller and the console.

Ensure the controller is fully charged. Reduce RGB lighting brightness or turn it off to conserve power. Avoid leaving the controller on when not in use.