Polycell Ready Mixed Filler - White

Surface dry time is typically 1 to 2 hours, depending on environmental conditions.

Yes, Polycell Ready Mixed Filler is suitable for both interior and exterior use.

It's generally recommended to clean the surface to remove loose material. Priming is not always necessary, but can improve adhesion on some surfaces.

Store in a cool, dry place and protect from frost. Always replace the membrane and lid to prevent the filler from drying out.

Yes, once fully dried, you can sand the filler to create a smooth surface.

It is suitable for plaster, masonry, concrete, and brickwork.

Yes, once the filler is completely dry, you can drill into it.

The VOC content is minimal.

Ensure the surface is clean and dry. Check the product's expiration date. Ensure adequate ventilation.

For deep holes, apply in layers, allowing each layer to dry completely before adding the next. Ensure the filler is not applied too thickly in one go.

Use a wet filling knife to smooth the surface. Apply with even pressure.

Make sure you are not applying to thick a layer, multiple thin layers are better for larger holes.

Ensure the surface is free from dust, grease, or loose particles. Use a primer if necessary. Make sure the filling knife is clean.