MDPE Pipe - 25mm x 150mtr Blue

No, this MDPE pipe is designed specifically for cold potable water supply systems and is not rated for high-temperature hot water.

While it can be used for short exposed sections, MDPE is primarily designed for underground use and should be protected from direct, long-term UV exposure.

Yes, it is best practice to always use a stainless steel or plastic insert stiffener when connecting MDPE pipe to mechanical fittings to ensure the pipe maintains its round shape under compression.

A standard pipe cutter designed for plastic or a fine-tooth saw can be used. If using a saw, ensure you deburr the edge thoroughly after cutting.

Yes, the pipe is WRAS approved, meaning it is certified for use in systems conveying water for human consumption.

Ensure the pipe end is cut square, free of burrs, and that the insert stiffener is fully seated inside the pipe end before tightening the compression nut.

Use a small amount of non-toxic silicone lubricant on the O-ring inside the fitting and ensure the pipe end is properly chamfered.

Lay the coil flat and rotate the coil to dispense the pipe rather than pulling it off the side, which prevents twisting and kinking.