BISSELL CrossWave OmniForce - Grey

The BISSELL CrossWave OmniForce offers up to 30 minutes of cordless cleaning time on a full charge.

A full recharge of the battery typically takes 4 hours.

It is recommended to use only BISSELL-formulated cleaning solutions designed for the CrossWave OmniForce to ensure optimal performance and maintain warranty. Using other solutions may damage the machine.

After emptying the dirty water tank, place the machine in its docking station, ensure the clean water tank is filled, and press the self-clean button. The machine will flush water through the brush roll and internal components.

The OmniForce is suitable for sealed hard floors (tile, laminate, sealed wood, linoleum) and for refreshing low-pile area rugs. It is not intended for unsealed floors or standard carpet.

The filter should be cleaned regularly, typically after every few uses or when you notice reduced suction. It should be replaced according to the usage guidelines in the user manual, usually every 3-6 months depending on use.

The BISSELL CrossWave OmniForce comes with a 2-year warranty.

Ensure the battery is fully charged. Check that the battery is properly seated. If the issue persists, contact customer support.

Check if the dirty water tank is full or if the clean water tank is empty. Clean the filter and ensure the brush roll is not clogged with debris. Verify that the anti-clog features are clear.

Ensure the clean water tank is filled correctly and properly seated. Check for any blockages in the dispensing nozzle. Confirm the correct mode (PowerMop or Turbo Mode) is selected.

Ensure you are using the correct BISSELL cleaning solution for your floor type. Clean the brush roll and check for debris. Run the self-cleaning cycle to ensure all parts are clear.

Ensure the dirty water tank is correctly and securely locked into place. Check the tank and seals for any damage or debris that might prevent a proper seal.