Superfresco Easy Innocence Wallpaper - Grey - Metallic

Paste the Wall refers to the application method where the adhesive is applied directly to the wall surface, rather than to the back of the wallpaper. This method typically makes wallpapering quicker, cleaner, and often easier to manage, as the paper does not need to 'soak'.

Measure the height and total width of all walls you intend to wallpaper. Due to the `64cm` `Offset Design Match` repeat, you will need to account for extra paper for pattern alignment waste. A general rule for a standard 10m x 0.52m roll is it covers approximately 5.2 square meters, but using an online wallpaper calculator and adding an extra roll for safety is recommended, especially with patterned papers.

While this wallpaper is `washable` and can withstand some moisture, it is generally recommended for areas with low to moderate humidity, such as living rooms, dining rooms, and bedrooms. For high-humidity environments like full bathrooms or directly above kitchen sinks, a specialized kitchen/bathroom wallpaper or an alternative wall covering might be more suitable to prevent moisture damage.

This wallpaper features a specific metallic and textured design. Painting over it would obscure these aesthetic qualities and is generally not recommended, as paint may not adhere properly to the metallic parts or compromise the textured finish. If you wish to change the color, it is best to remove the wallpaper first.

Always use a high-quality, ready-mixed 'Paste the Wall' wallpaper adhesive. Specific instructions regarding the type and amount of paste are usually found on the wallpaper label or the paste packaging. Following the paste manufacturer's guidelines is crucial for best results.

Superfresco Easy wallpapers are typically designed for easier removal than traditional wallpapers. Being a 'Paste the Wall' product, it can often be peeled off in full strips when you decide to redecorate, assuming proper wall preparation and paste application during initial installation.

An 'Offset Design Match' means that the pattern on each consecutive strip of wallpaper will align correctly when the next strip is positioned at half the pattern repeat length, either above or below the pattern of the previous strip. For this wallpaper, the design repeat is `64cm`, so each subsequent strip will need to be dropped by `32cm` to match the pattern seamlessly across the wall.

Ensure walls are properly prepared (smooth, dry, and primed if porous). During application, use a wallpaper brush to firmly smooth out bubbles, working from the center to the edges. For small, dried bubbles, a tiny incision with a sharp blade can allow air to escape, then gently press flat. For larger issues, a wallpaper repair adhesive can be injected under the bubble.

Apply sufficient paste to the edges of the wallpaper strips. Check if the wall surface itself is too absorbent or uneven, which can affect adhesion. For lifting seams, carefully re-apply a small amount of wallpaper paste using a fine brush, then gently press the seam firmly back into place with a seam roller.

This wallpaper has an `Offset Design Match` with a `64cm` repeat. This means the pattern on each subsequent strip needs to be dropped by `32cm` (half of 64cm) to align correctly with the previous strip. Double-check your measurements and pattern alignment carefully before cutting and applying each strip.

Verify that you are using a high-quality, ready-mixed 'Paste the Wall' specific adhesive. Ensure that enough paste is applied evenly to the wall. Check if the wall surface was too porous (requiring a primer) or too smooth/non-porous (which can hinder adhesion).

As the wallpaper is `washable`, gently wipe the affected area with a soft, damp cloth. For more stubborn marks, use a mild, diluted detergent solution. Always test any cleaning solution on an inconspicuous area first. Avoid harsh chemicals or abrasive scrubbing to protect the metallic finish and texture.