Hammerite - Smooth Direct To Rust - 750Ml - Grey

It is best to lightly abrade or prime glossy surfaces before applying Hammerite Direct To Rust Smooth paint for optimal adhesion. Always test on a small area first.

The paint offers a coverage of approximately 5 square meters per litre, depending on the surface texture and application thickness.

You can recoat the surface after approximately 4 hours, provided conditions are suitable (e.g., good ventilation and temperature).

Yes, this paint is designed to be applied directly onto bare, sound rust or clean metal surfaces without the need for a primer.

This paint is designed for general decorative and protective use on metal and is not specifically formulated for high-temperature applications like engine parts or exhaust systems.

A good quality synthetic brush or a short-pile roller is recommended for best results. Avoid using foam rollers as they may not provide an even finish.

Store the paint in a cool, dry place, away from direct sunlight and frost. Ensure the lid is tightly sealed to maintain the paint's quality.

Ensure the surface was properly cleaned and free of grease, oil, or loose rust. For non-ferrous metals or plastics, a suitable primer may be required. Always test on a small area first.

Stir the paint thoroughly before and during use. Apply in thin, even coats using a good quality brush or roller. Avoid over-brushing or over-rolling.

Ensure application conditions are within the recommended temperature and humidity ranges (typically above 10°C and below 85% humidity). Avoid applying too thickly, as this can prolong drying times.

Use a high-quality synthetic brush and a consistent application technique. Consider using a roller for larger, flat surfaces. Apply thin coats and allow adequate drying time between coats.