Setup, Compatibility & Care
Setup (Fitting Instructions)
- Boil Water: Bring a pot of water to a rolling boil.
- Submerge Mouthguard: Carefully place the mouthguard into the boiling water for `60 seconds` (or as per specific package instructions). Use a slotted spoon.
- Cool Slightly: Remove the mouthguard and immediately dip it in cool water for `1-2 seconds` to cool the outer layer, but keep the inner gel soft.
- Position and Bite: Place the mouthguard into your mouth, centering it over your upper teeth. Bite down firmly, sucking in to create a vacuum, and use your fingers to press the mouthguard against your teeth and gums for `20-30 seconds`.
- Set the Mold: Remove the mouthguard and place it in cold water for `30 seconds` to set the impression.
- Check Fit: Test the fit. It should feel snug and secure, staying in place without needing to be held. If the fit isn't perfect, you can usually repeat the process `1-2 times`.
Compatibility
The Shock Doctor Gel Max Mouthguard is compatible with a wide array of contact and non-contact sports where dental protection is recommended or required, including but not limited to:
- Football
- Hockey
- Basketball
- Lacrosse
- Martial Arts
- Boxing
- Rugby
- Wrestling
- Soccer (recommended)
Care
- Clean After Each Use: Rinse the mouthguard thoroughly with cold water after every use. You can also use a toothbrush and mild soap or a denture cleaner solution for a deeper clean.
- Store Properly: Always store your mouthguard in a clean, ventilated case to prevent bacterial growth and protect it from damage. Avoid leaving it in direct sunlight or hot environments.
- Inspect Regularly: Check for any signs of wear, tear, or damage. A damaged mouthguard may not offer adequate protection and should be replaced.
- Avoid Chewing: Do not chew on your mouthguard, as this can compromise its protective structure and fit.