JG Speedfit MDPE Equal Tee - 25mm

No special tools are required for installation. You may need a pipe cutter and, for plastic pipes, a pipe insert.

Yes, the fitting is demountable and can be reused. However, it's recommended to replace the pipe insert when remounting a plastic pipe connection.

Use the pipe insert recommended by the pipe manufacturer.

Ensure the pipe is fully inserted into the fitting and the nut is properly tightened. Check for any gaps or imperfections.

Yes, this fitting is suitable for use with both hot and cold water applications within the specified temperature and pressure ratings.

Pressure ratings will vary, please refer to the product specifications for the exact rating.

Store the fittings in a clean, dry place, away from direct sunlight and extreme temperatures.

Ensure the pipe is fully inserted and the nut is properly locked. Check for any damage to the pipe or fitting. If necessary, demount and reassemble, making sure to use a new pipe insert if applicable.

Ensure the pipe end is clean and properly cut. Check for any burrs or imperfections on the pipe. Use pipe lubricant to aid insertion if needed.

Make sure the nut is unlocked, and apply pressure to the collet while pulling the pipe. If necessary, use a demounting tool.