Trespass Faithful Parka Jacket - Grey - 8

The hood itself is 'grown-on', meaning it's a permanent part of the jacket. However, the faux fur trim around the hood is removable, allowing for versatile styling and easier care.

A 3000mm waterproof rating means the fabric can withstand 3,000 millimeters of water in a column before water starts to penetrate. This indicates good resistance to light to moderate rain and snow, suitable for everyday use and less extreme conditions.

Always refer to the care label inside your jacket. Generally, remove the faux fur trim, close all zippers, and machine wash on a gentle cycle with cold or lukewarm water using a specialized technical cleaner for waterproof fabrics. Avoid fabric softeners and bleach. Air dry the jacket.

Yes, with its padded construction and furry fleece lining, the Trespass Faithful Parka provides significant warmth. For extremely cold conditions, layering with appropriate base and mid-layers underneath will further enhance its insulating capabilities.

MVP stands for Moisture Vapour Permeability. A 3000mvp rating means that 3,000 grams of moisture vapor can pass through a square meter of the fabric in 24 hours. This indicates good breathability, helping to prevent sweat buildup and keep you comfortable during active use.

While the exterior fabric of the jacket is waterproof and the seams are taped, the internal pockets may not be fully sealed or waterproof. For sensitive items like electronics in heavy rain, it's advisable to use additional waterproof pouches within the pockets.

This indicates the DWR (Durable Water Repellent) finish has worn off. Wash the jacket with a technical cleaner, then apply a new DWR treatment (spray-on or wash-in) specifically designed for waterproof outerwear. Tumble drying on low heat may also reactivate the existing DWR.

Ensure you are wearing appropriate layers underneath. Cotton layers can absorb sweat and reduce overall breathability. Use moisture-wicking base layers. Also, ensure the jacket is clean, as dirt and oils can clog the breathable membrane. Re-proof if necessary.

Check for any fabric caught in the zipper teeth. Clean the zipper teeth with a small brush and mild soap, then apply a zipper lubricant or a small amount of graphite from a pencil to the teeth.

Remove the faux fur trim from the hood. Gently hand wash it in cool water with a mild detergent or spot clean with a damp cloth. Air dry away from direct heat. Once dry, gently brush or fluff the fur to restore its texture.