Best current price£6.91from Professional Building Supplies
Shopping.co.uk recommended and popular offers
Professional Building Supplies£6.91Visit shop Floplast Grey Push Fit Waste Pipe - 40Mm X 3Mtr
Visit shop3 offers from £6.91 - £18.00
View price history by clicking the chart icon.
The FloPlast Push Fit Waste Pipe is designed for trade professionals and DIY enthusiasts looking for a reliable, time-saving solution for internal wastewater drainage systems. Its primary benefit is the rapid, tool-free installation enabled by the push-fit mechanism, which removes the need for messy solvent welding. While highly efficient for standard plumbing configurations, users should note that it is strictly intended for internal use and must be cut accurately to ensure the integrity of the push-fit seals.
| Model Part Number | WP02G |
|---|---|
| Brand | FloPlast |
No, this push-fit system is specifically designed for internal domestic wastewater applications only.
No, this is a push-fit system. Using solvent cement on these fittings is unnecessary and may damage the rubber seals.
It is manufactured in the UK in accordance with BS EN 1451 standards.
No, you would need specific reduction fittings or a different pipe size, as this is a 40mm diameter pipe.
Use a fine-toothed saw to cut the pipe square, then use a file or sandpaper to remove any rough burrs from the edge.
Yes, it is designed to handle the temperatures typical of residential kitchen and bathroom wastewater, such as from dishwashers.
Check that the pipe end is de-burred and free of debris. Ensure the pipe is fully inserted into the fitting to seat the internal seal.
Apply a small amount of silicone-based lubricant to the pipe end to help it slide past the internal seal.
Install additional pipe support clips to maintain the required gradient for proper water flow.
To ensure a watertight seal, cut the pipe square using a fine-toothed saw and ensure the edge is smooth and free of burrs. When inserting the pipe into the fitting, push it fully home to engage the seal, then pull back approximately 10mm to allow for thermal movement. Ensure the pipe is properly supported with appropriate clips at regular intervals to prevent sagging. The system is compatible with standard 40mm FloPlast push-fit fittings. For maintenance, keep the pipe free of heavy debris and avoid using harsh caustic drain cleaners that might compromise the internal rubber seals over an extended period.
FloPlast Round Downpipe - 68mm x 2.5M GreyFrom £9
Solvent Waste Pipe - 50mm - 3m - BlackFrom £16
Round Downpipe - 68mm x 4mtr - Anthracite GreyFrom £17
Wavin OsmaWeld Plain Ended Pipe - 32mm - White - 3mFrom £11
Wavin OsmaWeld Plain Ended Pipe - 40mm - 3mFrom £13
Wavin OsmaWeld Waste Pipe - 50mm - 3M - WhiteFrom £15
Wavin OsmaWeld - 40mm - Black - 3mFrom £13
GoodHome Hard Surface Protector Roll - 20M L x 0.83M WFrom £22
FloPlast Miniflo Round Downpipe - 50mm Dia - 2m L - GreyFrom £11
Wavin Osma Push-Fit Waste Pipe - 40mm - 3m - WhiteFrom £8
GoodHome Self-Adhesive Protector Roll - 20M x 0.6MFrom £11
Round Downpipe - FloPlastFrom £11