John Guest Mdpe Compression Equal Tee - 25mm

This fitting is specifically designed for 25mm MDPE (Medium Density Polyethylene) pipes.

Yes, it is approved for use in potable water systems.

Standard tools like pipe cutters and wrenches are typically sufficient for installation. No specialized tools are required.

Ensure the pipe is cut square, clean, and fully inserted into the fitting. Tighten the compression nut firmly, typically a quarter to half turn past hand-tight.

This fitting is designed for water systems. It is not suitable for gas lines.

Overtightening can damage the fitting or the pipe, potentially leading to leaks or compromising the structural integrity of the connection.

Each pack contains 10 equal tee fittings.

Ensure the pipe is fully inserted into the fitting and the compression nut is tightened appropriately. Check for damage to the pipe end or fitting. Re-seat the pipe and retighten the nut, avoiding overtightening.

Verify that you are using the correct size (25mm) MDPE pipe. Ensure the pipe end is clean, square, and free of debris or deformation.

Confirm the pipe is the correct type (MDPE) and size. Check the pipe for any nicks or damage that could prevent a good seal. Ensure the compression ring and nut are properly seated.