ADATA LANCER BLADE RGB DDR5 - Black

DDR5 offers significantly higher bandwidth, improved power efficiency, and enhanced features like On-die ECC for greater stability compared to DDR4.

You need to enter your computer's BIOS/UEFI settings during boot-up (usually by pressing DEL or F2). Look for memory settings and enable the XMP (for Intel) or EXPO (for AMD) profile. Save changes and exit.

It is highly recommended to use identical modules for optimal performance and stability, especially if aiming for dual-channel mode. Mixing different speeds, timings, or brands can lead to compatibility issues or reduced performance.

Using multiple RGB control software from different manufacturers (e.g., XPG Prime and MSI Mystic Light simultaneously) can lead to conflicts, causing lighting effects to freeze, behave erratically, or not function at all. It's best to use one primary control software. If conflicts arise, you may need to uninstall one, reboot, and then reinstall your preferred software. Refer to the product's specific instructions for detailed guidance.

No, this is a DIMM module designed for desktop PCs. Laptops typically use smaller SO-DIMM modules.

CAS latency (CL) is the delay between the memory controller telling the memory module to access a specific column in a row and the data from that column being available. A lower CL number (like 30) means less delay, resulting in faster performance, especially in latency-sensitive applications like gaming.

Yes, the XPG LANCER BLADE RGB DDR5 features On-die ECC, which helps correct errors internally to improve data integrity and system reliability.

Ensure the module is fully seated in the RAM slot. Check your motherboard manual for the correct slot configuration. Try booting with a single module. Verify motherboard compatibility with DDR5 memory and the specific speed (6000 MHz).

If overclocked, revert to default speeds or try a slightly lower frequency. Ensure adequate power supply to the system. Check for overheating. Run a memory diagnostic tool to test for errors.

Ensure the XPG Prime software or your motherboard's RGB control software is installed and running. Close any other conflicting RGB control software. Update your motherboard's BIOS and RGB software. Check connections if applicable (though this is a module-based feature).

Verify that XMP or EXPO is enabled in the BIOS/UEFI. Ensure the memory is running at the advertised speed (6000 MHz) and not a default JEDEC speed. Check that the module is in the correct slot for dual-channel operation if using multiple sticks.