Dulux Trade Vinyl Matt 2.5L - Brand: Dulux Trade - MPN: 5082980

While suitable for general interior use, for areas with high humidity or frequent moisture, a vinyl silk or specific kitchen/bathroom paint might offer better durability and resistance to condensation.

The paint covers approximately 17m² per litre. Calculate the area of your walls and ceiling (length x height) and divide by 17 to estimate the litres needed. Always purchase slightly more than calculated to account for touch-ups or variations in surface absorption.

Dulux Trade Vinyl Matt is specifically designed for interior walls, ceilings, and drywall. It is not recommended for use on bare wood or metal surfaces, which require specific primers and finishes.

The paint typically dries to the touch in 4 hours. It can be recoated after a minimum of 4 hours, dependent on temperature and humidity.

Dulux Trade Vinyl Matt has a very low VOC content, labelled as 'Minimal (0 - 0.29%)' and specified as 1 g/l. This contributes to its low odour and suitability for indoor environments.

Yes, once fully cured, surfaces painted with Dulux Trade Vinyl Matt can be wiped clean with a damp cloth and mild detergent. Avoid abrasive cleaners.

Yes, this product is available in a Light Base and can be tinted to thousands of colours, including RAL and BSC shades, or colour-matched to other existing paint colours.

Ensure surfaces are properly prepared and dry. Apply a thinned first coat for bare surfaces. Check if sufficient coats have been applied based on the colour change or surface condition. Ensure paint is stirred thoroughly.

Ensure the paint is applied evenly and avoid overworking it. Use a good quality brush or roller suitable for emulsions. Ensure paint is not applied too thickly. Allow adequate drying time between coats.

This may be due to uneven surface porosity or inconsistent application. Ensure the first coat was adequate to seal the surface. Apply subsequent coats evenly, maintaining a wet edge.

Stir the paint thoroughly. If too thick, a small amount of water (as per dilution notes) can be added for spray application or extremely porous surfaces. If too thin, ensure the lid was securely closed to prevent drying.