Lieber Silk White 2 Gang 2 Way Intelligent Dimmer - 150W LED

No, using non-dimmable bulbs with this dimmer can cause damage to the bulb, the dimmer, or result in poor performance such as flickering or buzzing. Always use bulbs explicitly marked as 'dimmable'.

The maximum load for dimmable LED bulbs is 150W.

The dimmer features an easy push-button setup. Refer to the product manual for specific instructions on how to access and change this setting.

This dimmer supports 2-way switching, meaning one dimmer can be paired with one standard 2-way switch for control from two locations. For control from three or more locations, a different wiring configuration or specialized switches would be required.

Soft-start technology gradually increases the light output over 1-2 seconds when the light is turned on. This reduces the initial power surge, prolonging the life of the light bulbs.

While the dimmer has an easy setup, electrical wiring should only be performed by a qualified person familiar with local electrical codes and safety standards. If you are not experienced with electrical work, we recommend hiring an electrician.

The dimmer has a smooth satin white finish.

Ensure the circuit breaker is on. Check all wiring connections are secure and correct according to the installation diagram. Verify the bulb is compatible and correctly installed.

Confirm that the installed bulbs are specifically 'dimmable'. Check that the total load does not exceed the maximum (150W for LED, 300W for Halogen/Incandescent). Try switching the dimmer to the other edge mode (leading/trailing) using the setup button.

Some warmth is normal, especially under maximum load. If it becomes excessively hot, turn off the power immediately and check the bulb wattage against the maximum load rating. Ensure adequate ventilation around the unit.

Verify that the additional switch used is a standard two-way switch and that all wiring between the dimmer and the auxiliary switch is correct. Ensure the dimmer is correctly wired into the circuit.