Makita Drywall Cutting Bit - 3.18mm

This bit is specifically designed for use on drywall/plasterboard.

It is compatible with the Makita DCO180Z Drywall Cutter.

Insert the bit into the chuck of the Makita DCO180Z and tighten securely.

Use a brush or compressed air to remove drywall dust after each use.

The diameter of the bit is 3.18mm.

Replacement bits can be found at most hardware stores or online retailers that carry Makita products.

Always wear eye protection and a dust mask when using the bit. Ensure the work area is well-ventilated.

Check if the bit is dull and replace if necessary. Also, ensure the bit is properly installed and the drywall cutter is set to the correct speed.

Reduce the cutting speed, and clear the waste more frequently.

Ensure the bit is sharp and the drywall cutter is stable. Slow down the cutting speed, and apply even pressure.