Setup, Compatibility & Care
Installation should always be performed by a qualified electrician to ensure safety and compliance with building regulations.
- Surface Prep: Ensure the mounting surface is flat and capable of supporting the die-cast housing.
- Wiring: Connect the mains supply to the internal terminal block, ensuring the emergency override circuit is connected as per the provided wiring diagram.
- CCT Selection: Before closing the diffuser, select the desired colour temperature (3000K, 4000K, or 6000K) on the gear tray switch.
- Sealing: Ensure the gasket is properly seated before tightening the lens to maintain the IP65 rating.
- Care: Clean the polycarbonate diffuser periodically using a soft, damp cloth and mild soapy water; avoid abrasive cleaners or solvent-based chemicals that could cloud the lens.