Best current price£8.85from eBay
Shopping.co.uk recommended and popular offers
eBay£8.85Visit shop Isopon U-Pol Powercan Etch Primer Spray Paint Aerosol Anti-Corrosive 500ml
Visit shop
B&Q£10.59Visit shop B&Q - U-Pol Powercan Etch Primer Anti-Corrosive 500Ml
Visit shop13 offers from £8.85 - £31.98
View price history by clicking the chart icon.
This guide is for anyone using U-POL Powercan Etch Primer, a product designed to prime bare metal surfaces. The key benefit is its ability to promote paint adhesion and prevent rust. A key consideration is that proper surface preparation is crucial for optimal results. This guide covers key features, usage, troubleshooting, and care instructions to help you get the best performance from your U-POL Powercan Etch Primer.
| Colour | Grey |
|---|---|
| Model Part Number | 0830 |
| Brand | U-POL |
U-POL Powercan Etch Primer is suitable for bare steel, aluminum, galvanized and zinc-coated steels, fully cured paint, polyester body fillers, and G.R.P.
Drying times vary. Refer to the product label for specific instructions based on temperature and humidity.
Generally, sanding the primer is not required before applying a topcoat. However, check the topcoat's instructions for specific recommendations.
Store the can in a cool, dry place away from direct sunlight and heat.
This primer is generally not designed for use on plastic. Always check the product label for compatibility information.
Clean the nozzle after each use. If it clogs, try using a pin to clear the blockage or replace the nozzle.
One or two thin coats are usually sufficient. However, for maximum protection, two thin coats are recommended. Allow each coat to dry fully before applying the next one.
It is designed to prime bare metal surfaces, promote paint adhesion, and prevent rust.
Ensure the surface is properly prepared by cleaning and sanding it. Make sure the surface is free of any contaminants.
Apply thinner coats and avoid applying too much primer in one go. Keep the can the correct distance away from the surface.
Clean the nozzle after each use. If clogged, try using a pin to clear the blockage or replace the nozzle.
