Sikkens Cetol HLS Plus Woodstain - Pine - 1L

When used alone, three coats are recommended for optimal protection. When used as a base coat with Sikkens Cetol Filter 7 Plus, apply one coat of HLS Plus followed by two coats of Filter 7 Plus.

It is suitable for exterior wooden surfaces including softwoods, hardwoods, plywood, block board and particle board, claddings, fascias, architraves, timber frames, fences and sheds.

No, this product should not be used on substrates that have been treated with water-repellent wood preservatives or pre-treatments containing wax, oil, or silicone.

It offers a translucent, semi-gloss finish.

Ensure the wood surface is clean, dry, and free from any previous coatings or contaminants. Lightly sand the surface if necessary.

Drying times vary. Always refer to the manufacturer's instructions on the product label for specific drying times under various conditions.

Yes, it can be used on windows and doors. Apply one coat of HLS Plus followed by two coats of Filter 7 Plus for best results.

Ensure proper surface preparation before application. Remove any previous coatings or contaminants. Apply thin, even coats, and avoid over application. Allow adequate drying time between coats. If the problem persists, the wood may have been pre-treated with incompatible products, consider alternative products.

Stir the product thoroughly before and during application. Apply even coats, avoiding thick spots or drips. Ensure uniform application along the wood grain.

Ensure proper ventilation during application and drying. Check the temperature and humidity levels, as this can affect drying times. Make sure the applied coat is not too thick.

Clean the surface with a suitable mold and algae remover. Ensure proper ventilation. Consider reapplying Sikkens Cetol HLS Plus to help prevent future growth.