John Guest Compression Fitting - Male Thread Adaptor - 25mm X 3/4"

This adaptor is specifically designed to connect to 25mm MDPE (Medium Density Polyethylene) pipe.

The other end has a 3/4 inch male thread, suitable for connecting to standard female threaded fittings.

Yes, John Guest fittings are engineered for strength and reliability and are suitable for standard water pressure applications.

Ensure the MDPE pipe is fully inserted, the nut is tightened correctly, and the 3/4 inch threaded connection is properly sealed using appropriate methods like PTFE tape if needed.

It is compatible with standard 3/4 inch male threaded fittings. Ensure the fitting you are connecting to is designed to accept this thread size.

Yes, John Guest fittings are widely used in potable water systems.

The adaptor connects 25mm MDPE pipe to a 3/4 inch male thread.

Ensure the pipe is fully inserted into the fitting and the nut is tightened securely. Check the pipe end for damage or imperfections and re-cut if necessary. Verify the retaining collar is correctly positioned.

Ensure the male thread is clean and free of debris. Check that the female fitting is not damaged. Use appropriate PTFE tape or sealant on the male thread if the female fitting does not have an integrated seal, and tighten securely.

Make sure the pipe end is cut perfectly square and is free of any deformation. Slightly warming the pipe end with warm water (not heat gun) can sometimes make insertion easier.