Fresco Wooden Slat Wallpaper - Grey

No, the Fresco Wooden Slat Grey Wallpaper is a high-quality wallpaper designed to realistically mimic the appearance of real wooden slats, providing the aesthetic without the material.

It is recommended to use a good quality, ready-mixed wallpaper paste, ideally one suitable for non-woven or heavy-duty wallpapers, for optimal adhesion with the paste-the-paper method.

Measure the height and width of your wall(s). Calculate the total square meterage and divide by the coverage per roll (0.52m x 10m = 5.2 sq meters). Always account for pattern repeat and add an extra roll to allow for cutting, trimming, and potential errors.

This wallpaper is best suited for dry, low-humidity environments such as living rooms, bedrooms, and hallways. It is not specifically designed for high-humidity areas and may not perform well in a bathroom or kitchen with high moisture.

The wallpaper can be gently wiped clean with a soft, damp cloth. Avoid using abrasive cleaners, harsh chemicals, or excessive scrubbing to prevent damage to the design.

While it's not a peel-and-stick product, standard wallpaper removal methods like wetting and scraping, or using a wallpaper steamer, can be used. The ease of removal can depend on the wall preparation and paste used.

While technically possible, painting over this wallpaper is not recommended as it would cover the distinctive wooden slat design, defeating the purpose of its aesthetic appeal. If you want a different color, it's better to remove and replace it.

Gently smooth the wallpaper from the center to the edges with a wallpaper smoother or brush to push out trapped air. If the paste is still wet, you can carefully lift a corner and re-smooth. For stubborn bubbles once dry, a small incision with a sharp knife and re-smoothing may be necessary, or a small amount of paste injected with a syringe.

This often occurs if the initial strip was not hung perfectly straight using a plumb line, or if strips were cut without carefully aligning the pattern repeat. Ensure meticulous measurement and alignment for all subsequent strips. If the mismatch is minor, it may become less noticeable once fully dried; for significant errors, re-hanging the affected strips might be necessary.

Check if the wall surface was properly prepared (clean, dry, smooth, and possibly primed). Ensure you are using a suitable, good quality wallpaper paste for non-woven or heavy-duty wallpapers and that it was applied evenly to the wall. Insufficient paste or an unsuitable wall surface can prevent proper adhesion.

Wipe off any excess paste immediately with a clean, damp sponge as you work. It's crucial to remove paste before it dries, as dried paste can be difficult to remove without damaging the wallpaper or leaving a residue.