Crown Easyclean Bathroom Paint - Powdered Clay

While specifically formulated for bathrooms due to its anti-mould and humidity-resistant properties, it can certainly be used in other areas of the house where a durable, washable, mid-sheen finish is desired, especially in areas prone to dampness.

Info needed: [drying time for touch dry and recoat]. Always refer to the specific instructions on the paint can for accurate drying times.

A primer is generally recommended for unpainted, porous, or significantly contrasting surfaces to ensure optimal adhesion and color depth. If painting over a previously painted surface in good condition, it may not be strictly necessary, but good preparation is key.

Info needed: [coverage per liter]. The coverage depends on the surface porosity and previous color. As a general guide, a 2.5L can often covers a small to medium-sized bathroom with two coats. Measure your wall and ceiling area and consult the paint can for specific coverage rates.

This specific product is pre-mixed in `Powdered Clay`. Info needed: [Does Crown offer custom tinting for this specific line?]. For other color options, explore other variants in the Crown Easyclean Bathroom Paint range.

A mid-sheen finish has a slight soft gloss, providing a more reflective surface than matte but less than full gloss. It's durable, easy to clean, and helps brighten rooms by reflecting some light.

Ensure all existing mould was thoroughly removed and the surface treated with an anti-mould solution *before* painting. The paint protects the film, but cannot eradicate mould from underlying surfaces. Also, ensure adequate ventilation in the bathroom.

This can occur if the surface was not properly prepared (e.g., not clean or dry) or if there was excessive condensation during the drying process. Ensure surfaces are perfectly dry before painting and maintain good ventilation during and after application. Allow sufficient drying time between coats.

Ensure the paint was thoroughly stirred before and during application. Apply an even coat with a good quality brush or roller, maintaining a 'wet edge' to prevent lap marks. Two coats are usually recommended for a uniform finish.