Silverhook Under Seal Spray Schutz 1L - SGUS2

Clean the surface thoroughly to remove loose rust, dirt, and grease. Use a wire brush or abrasive cleaner. Ensure the surface is dry.

While primarily designed for metal, wood and concrete, test on a small area first to ensure compatibility and adhesion.

Apply multiple thin coats for best results, usually two or three coats are sufficient, allowing each coat to dry before applying the next.

Drying times vary depending on temperature and humidity. Refer to the product label for specific drying times. Typically it is touch dry in an hour and fully cured in 24 hours.

Clean the nozzle with a suitable solvent or replace it with a new one. After use, invert the can and spray until only propellant comes out to prevent clogging.

Yes, Silverhook Under Seal is suitable for use on felt roofs to repair leaks and provide waterproof protection.

Use in a well-ventilated area. Wear appropriate personal protective equipment, including gloves and eye protection. Avoid inhaling the spray. Keep away from heat and flames.

Ensure the surface is clean, dry, and free from contaminants. Roughen the surface slightly to improve adhesion.

Clean the nozzle with solvent or replace it. Invert the can and spray until only propellant comes out after use.

Apply thinner coats and avoid applying too much product at once. Allow each coat to dry before applying the next.

Ensure proper surface preparation. Apply within the recommended temperature range. Apply thin coats, avoid thick applications.