Amtech Desoldering Pump Kit - S1760

No, the kit contains one desoldering pump and two desoldering wicks. A soldering iron must be purchased separately.

The nozzle is designed for long-term use, but it should be cleaned regularly to maintain suction performance.

The Amtech Desoldering Pump Kit is covered by a 3-year warranty.

Place the wick over the solder joint and press your hot soldering iron tip onto the wick. The solder will wick up into the braid as it melts.

Yes, it is designed for electronics repair, but ensure you do not apply excessive heat to the board while using the pump to prevent trace damage.

Unscrew the front nozzle to access the chamber and clear out any accumulated solder beads.

Check the nozzle for solder blockages and ensure the seal around the plunger is tight; clean out any debris inside the barrel.

Apply a tiny amount of heat-resistant lubricant to the plunger seal and ensure no internal solder beads are obstructing the path.

Ensure your soldering iron is at the correct temperature and apply a small amount of flux to the wick before touching the solder joint.