Setup, Compatibility & Care
Setup Instructions
- Prepare the Surface: Ensure the surface is perfectly clean, dry, and smooth. Remove any dust, grease, or loose particles. For rough or porous surfaces, a primer may be necessary for optimal adhesion.
- Measure and Cut: Measure your surface accurately. Use the grid lines on the backing paper to cut the film to the desired size, leaving a small overlap (about 1-2 cm) for trimming.
- Peel and Stick: Carefully peel back a few centimeters of the backing paper from one corner. Align the exposed adhesive edge with your starting point on the surface.
- Apply Gradually: Slowly peel off more backing paper with one hand, while simultaneously smoothing the film onto the surface with your other hand or a squeegee. Work from the center outwards to push out any air bubbles.
- Remove Air Bubbles: If bubbles occur, gently lift the film and re-apply, or use a pin to prick small bubbles and smooth them down.
- Trim Excess: Once applied, use a craft knife or sharp blade to carefully trim any excess film along the edges for a neat finish.
Compatibility
This adhesive film is compatible with any smooth, clean, and dry surface. This includes: laminate, glass, metal, plastic, painted wood (smooth finish), and tiles. It is not recommended for heavily textured, porous, damp, or freshly painted surfaces (wait at least 3 weeks after painting).
Care and Maintenance
- Cleaning: Wipe the film clean with a damp cloth and mild detergent. Avoid abrasive cleaners or harsh chemicals, which can damage the surface.
- Heat Exposure: While heat-resistant up to 70°C, avoid placing extremely hot items directly onto the film for extended periods. Use coasters for hot drinks or dishes.
- Maintenance: Regularly check edges for lifting and gently press down to ensure continued adhesion.