John Guest MDPE Compression Elbow - 90 Degree - 25mm

This elbow is specifically designed for 25mm MDPE (Medium Density Polyethylene) pipe.

No, this fitting is approved and designed for cold water systems only.

No, installation is straightforward using a compression mechanism that requires basic tools like a wrench. Ensure the pipe is clean and properly inserted.

WRAS (Water Regulations Advisory Scheme) approval means the product has been rigorously tested and meets the high standards set for products that come into contact with drinking water in the UK.

Each pack contains 15 John Guest MDPE Compression Elbows.

Yes, this fitting is suitable for both below-ground and above-ground cold water applications.

Check that the pipe is fully inserted and the compression nut is tightened to the recommended torque. Ensure the pipe end is clean and undamaged. If the problem persists, consider replacing the fitting or pipe section.

Ensure the pipe is fully inserted into the fitting and that the compression nut is tightened sufficiently. Check the pipe end for damage or dirt; re-cut if necessary and re-install. Verify the correct pipe size is being used.

Confirm the pipe is the correct 25mm MDPE. Ensure the pipe end is clean, free of burrs, and slightly chamfered if needed. Warming the pipe end slightly in warm water can sometimes help with insertion.

This is rare with compression fittings. Ensure the pipe is fully seated and the nut is adequately tightened. If the issue persists, the pipe may be deformed, or the fitting may be damaged.