FloPlast Half Round Union Bracket - Brown - 112mm

This bracket is specifically designed for 112mm half-round guttering systems.

The product description does not specify the exact material, but it is made by FloPlast, known for durable and high-quality construction.

Clean the bracket with a mild detergent and water. Avoid using abrasive cleaners or solvents.

Insert the gutter sections into the union, aligning them with the insertion marks. Clip the gutter into place by inserting the back edge first and then gently pulling the front edge down until it clicks.

You will need a screwdriver or drill to attach the union bracket to the fascia board, and potentially a saw or cutter to prepare the gutter sections (if needed).

The insertion marks show exactly where the gutter should be positioned to ensure a proper seal and accommodate expansion and contraction due to temperature changes.

Use countersunk screws suitable for exterior use and the material of your fascia board.

Check the alignment of the gutter sections within the union. Ensure the clips are properly engaged and that the rubber seal is compressed evenly. Tighten the screws if necessary.

Check the screws securing the union bracket to the fascia board. Tighten them if loose, or replace them if damaged. Ensure that the gutter is correctly positioned.

Ensure the gutter is properly aligned with the insertion marks. Check for any obstructions or debris in the union. Apply gentle pressure to the front edge until the clip snaps into place.