Drybase Plaster Membrane Plugs - Orange

The plugs are 8mm in diameter and 60mm in length.

These plugs are suitable for brick, concrete, and stone substrates.

You will need an 8mm drill bit and a hammer.

These plugs are designed for use with Drybase plaster membranes. Always check the plaster membrane's manufacturer instructions for compatibility.

Ensure the plugs are fully inserted and that the membrane is securely attached, covering the plug heads completely.

Check the hole size. You might need to adjust your drill bit size. Also, clear any debris from the hole.

Yes, the plugs are designed to be covered with board adhesive, plaster, and a skim finish, which can then be painted.

Check the hole diameter and depth. Ensure the hole is clean and free of debris. Use a slightly smaller diameter drill bit for a tighter fit or use a different hammer to drive the plug.

Avoid over-hammering. If this happens, try a gentler hammer or replace the plug.

Ensure plugs are driven in fully. Check the membrane for proper adhesion. Consider using additional adhesive.