Rasch Brick Effect Wallpaper - Beige - 226706

Each roll of Rasch Brick Effect Wallpaper (226706) measures 10 meters in length and 0.53 meters in width.

One roll covers approximately 5.32 square meters, taking into account the pattern repeat and wastage during application.

The wallpaper is washable. You can gently wipe it with a damp sponge or cloth to remove light marks. Avoid harsh chemicals or excessive water.

The pattern repeat for this wallpaper is 53 centimeters.

While washable, this wallpaper is not specifically designed for high-moisture environments like bathrooms. Ensure good ventilation if used in such areas, and consider a suitable sealant if needed.

This is a paste-the-paper wallpaper. Apply the adhesive directly to the wallpaper, allow it to soak according to instructions, and then hang it on your prepared wall. Use a straight match for alignment.

Carefully align each strip according to the 53cm pattern repeat. Use a sharp trimming knife and a straight edge for precise cuts at the ceiling and skirting board. A wallpaper roller can help smooth out seams.

Ensure the wall was properly prepared and adhesive was applied evenly. Gently lift the edge, apply more adhesive if necessary, and press back into place using a wallpaper roller. Ensure adequate ventilation for drying.

Double-check the pattern repeat (53cm) and ensure each strip is placed correctly relative to the previous one. Make precise cuts with a sharp knife for a clean seam. Trimming slightly during application can help in achieving alignment.

This could be due to inconsistent adhesive application or the wallpaper not having sufficient 'booking' time. Ensure even paste coverage and allow the recommended soaking time before hanging. Also, verify all rolls used are from the same batch number.

Use a wallpaper smoothing tool or a clean, stiff brush to work air bubbles towards the nearest edge. Puncture stubborn bubbles with a fine needle and smooth down.