Osmo One Coat Only Hs Plus - Silver - 0.75L

The product coverage for 1 coat is approximately 26 m² per liter. Therefore, a 0.75L can should cover around 19.5 m².

This product is specifically recommended for wood in outdoor areas. For interior wood, Osmo offers different product lines suited for indoor applications.

Apply thinly and evenly using an Osmo Flat Brush or Microfibre Roller, following the direction of the wood grain. Spread it well to ensure uniform coverage.

Under good ventilation, the product typically takes approximately 12 hours to dry.

This product is best suited for bare wood or renewing old microporous finishes. Applying it over existing paint may lead to adhesion issues. Remove old paint if it is not microporous.

The 'Silver' color provides a subtle, cool tone to the wood, enhancing its natural appearance while offering protection. The final look depends on the wood's original color and porosity.

While suitable for outdoor wood, always check the specific wood type and perform a test application. For heavy-traffic deck areas, other specialized Osmo decking products might be more appropriate.

Ensure the product was applied thinly and evenly, spreading well along the wood grain. Insufficient stirring before application can also cause this. Check for any drips or thick spots and even them out while the product is still wet.

Ensure adequate ventilation during the drying process. Low temperatures or high humidity can significantly extend drying times. Avoid applying a second coat until the first is completely dry.

The wood surface may not have been properly prepared. Ensure it was clean, dry, and free from any contaminants. For old finishes, ensure they were microporous and adequately abraded if necessary for adhesion.

Color appearance can vary depending on the wood type and its original color. It is recommended to test the finish on an inconspicuous area first. The 'Silver' color provides a subtle, cool tone.