Plasson Mechanical Compression Coupling - 32x25mm

The coupling is compatible with both MDPE and LDPE pipes.

You will need a pipe cutter to cut the pipe squarely and a wrench for tightening the coupling nut.

The coupling is tested to withstand working pressures of up to 16 bar.

The coupling has a 50-year design life.

Yes, it is suitable for outdoor use and can withstand direct sunlight and frost.

The O-ring provides a watertight seal, preventing leaks.

Check the pipe insertion and nut tightness, and inspect/replace the O-ring or pipe liner if necessary.

A pipe liner is needed for MDPE pipes to provide proper support and ensure a secure, leak-free connection.

Ensure the pipe is fully inserted into the coupling, and the nut is properly tightened. Check the O-ring for damage and replace if necessary. If connecting to MDPE, verify the pipe liner is correctly installed.

Make sure the pipe ends are clean and free of debris. Use a suitable wrench to tighten the nut; do not overtighten.

Ensure the pipe end is cut squarely. Check for any burrs or damage on the pipe end and remove them. If using a pipe liner, make sure it's correctly inserted into the pipe.