TIMco Solo Coach Screws - Gold - 8.0 x 100

The primary advantage is their significantly faster installation time, up to 3x quicker, due to the aggressive slash point tip and power tool compatibility.

Yes, they have a zinc and yellow passivation finish offering Corrosion Resistance Rating 2, making them suitable for use in occasionally damp or sheltered outdoor areas.

You will need a 10mm socket to drive the hex flange head of these screws.

While not always strictly necessary in softwoods, pre-drilling is recommended for hardwoods, dense materials, and always when using in brick or masonry to ensure correct installation and prevent splitting.

The TIMco Solo Coach Screw is a modern replacement, featuring an improved slash point for faster driving and power tool compatibility, whereas the DIN 571 is a traditional design.

They can be used on softwood, hardwood, man-made board, and brick or masonry when used with a suitable nylon plug.

Pre-drill a pilot hole slightly smaller than the screw's core diameter. Ensure you are using adequate power from your tool.

Ensure the socket is fully engaged with the hex flange head. Reduce driving torque if using a power tool. Check that the socket size is correct (10mm).

Verify that a nylon plug has been inserted into the pre-drilled hole and that the hole is the correct size for the plug.

While rated for Corrosion Resistance 2, prolonged exposure to harsh or very wet conditions can cause surface rust. Clean the screw and consider applying a protective sealant if the environment is particularly aggressive.