MDPE Compression Connector Fittings - 25mm - 1/2" BSPM, Elbow

This fitting is specifically designed for 25mm outer diameter Medium Density Polyethylene (MDPE) pipes.

Basic tools like a pipe cutter and wrenches are typically needed. No special solvent or heat is required due to the compression design.

No, these fittings are designed and rated for water supply lines only.

It refers to a 1/2 inch British Standard Pipe Male thread, meaning it has external threads for connecting to female threaded components.

Ensure the pipe is cut squarely, inserted fully to the fitting's internal stop, and the compression nut is tightened appropriately according to instructions.

The listed dimensions are L-195mm x 290mm x 290mm, referring to the overall package or shipping dimensions, not the fitting's installed profile.

Ensure the pipe was fully inserted into the fitting body. Check that the compression nut and ferrule were correctly positioned and tightened adequately. If the problem persists, the fitting may need to be replaced.

Verify that the pipe is indeed 25mm MDPE and that the end is clean, square-cut, and free of deformation. Slightly warming the pipe end in hot water can sometimes help, but avoid overheating.

Ensure proper tools are used and avoid excessive force. Tighten only to the recommended level. If damage occurs, replace the fitting and inspect the pipe end.