Self Adhesive Film - Grey

For best results and optimal adhesion, this film is recommended for smooth, non-porous surfaces. Applying it to textured surfaces may result in poor adhesion, visible textures, and a less durable finish.

The film itself is water-resistant. It can be used in bathrooms on smooth, dry surfaces. However, for areas directly exposed to water, like inside showers or around sinks, ensure all edges are properly sealed to prevent water from getting underneath and compromising the adhesive.

To remove, gently peel up a corner and slowly pull the film back at a 45-degree angle. If it's difficult to remove, a hairdryer on a low setting can warm the adhesive, making it easier to peel off. Any minor residue can usually be cleaned with warm soapy water or an adhesive remover designed for vinyl.

Yes, it can be used on kitchen countertops to update their appearance. However, it's important to use cutting boards and trivets for hot items as the film is not heat-proof and can be cut or damaged by sharp objects.

Yes, the Marble Cortes Grey design has a pattern repeat. For larger areas requiring multiple rolls, lay out your pieces before cutting to align the pattern. This often involves cutting beyond the desired length to match the design seamlessly, so plan for extra material.

You will need a tape measure, a sharp utility knife or scissors, a straight edge (like a ruler), and a smoothing tool such as a squeegee or a credit card to press out air bubbles.

If bubbles occur, gently lift the film back to the bubble and re-apply, using a squeegee or credit card to press out the air as you smooth. For stubborn small bubbles, you can carefully prick them with a fine needle and smooth the air out.

Ensure the surface is completely clean, dry, and smooth before application. Any dust, grease, or texture can prevent proper adhesion. Also, avoid applying to very cold surfaces; room temperature is ideal.

During application, ensure all edges are firmly pressed down with a smoothing tool. For persistent lifting, a gentle application of heat from a hairdryer on a low setting can sometimes reactivate the adhesive, followed by immediate firm pressing. Apply edge sealant for high-moisture areas.

Always use a very sharp utility knife for clean cuts. For straight lines, use a metal ruler or straight edge as a guide. For curves, you can create a paper template first or use a craft knife for precision.