Polypipe 110mm Soil 135deg Offset Bend Double Socket White

A 135° offset bend is used to change the direction of pipework, typically to navigate around obstacles or to connect pipes that are not in direct alignment, offering more flexibility than a standard 90° bend.

Yes, this double socket bend is designed with compatibility for both push-fit ring seal connections and solvent weld connections.

This fitting is for 110mm nominal size pipes within soil and vent systems.

The Polypipe 110mm Soil 135° Offset Bend is suitable for above-ground soil and vent systems in residential and light commercial applications.

This component requires minimal maintenance. Ensure joints remain sealed and check for any external damage. Cleaning can be done with a damp cloth if needed.

If a joint leaks, first check that the pipe is fully inserted and the seal is correctly seated. If using solvent weld, ensure the joint was properly made and cured. The joint may need to be disassembled and re-made.

Ensure the pipe is fully inserted into the socket and the ring seal is correctly seated. If using solvent weld, confirm the joint was properly bonded with appropriate cement and sufficient curing time has passed. Re-make the joint if necessary.

Check for obstructions or debris inside the socket and on the pipe end. Ensure pipe ends are de-burred. Apply appropriate lubricant for ring seal joints.

Verify that the 135° offset bend is correctly installed and not contributing to an unnatural angle that impedes flow. Check for blockages further down the system.