E-Tech Chassis Paint - Jet Black 500ml

It is suitable for chassis, sub-frames, engine mounts, floor pans, axles, suspension arms, and other metal surfaces.

No, you can apply E-Tech Chassis Paint directly to prepared bare metal surfaces.

Clean the surface thoroughly to remove rust, dirt, grease, or loose particles. Use a wire brush or abrasive cleaner as needed. Ensure the surface is completely dry.

For best results, apply two or three thin coats, allowing each coat to dry according to the manufacturer's instructions.

Drying times vary depending on temperature and humidity. Refer to the product label for specific drying times.

The paint produces an original factory look with a satin finish.

The paint is available in Jet Black, Silver Alloy, and Gunmetal Grey.

Clean the painted surface with mild soap and water. Avoid abrasive cleaners or solvents.

Apply thinner coats and ensure the can is held at the correct distance from the surface. Avoid applying too much paint at once.

Ensure the surface is properly prepared and free of rust, grease, and dirt. Lightly sand the surface for better adhesion.

Ensure the surface is properly prepared. Apply even coats and maintain the correct distance from the surface when spraying.