Frenchic Virgin Trim Paint - White

No, Frenchic Virgin Trim Paint is formulated to be self-priming, meaning you can apply it directly to most prepared interior surfaces without a separate primer.

No, this paint is also self-sealing and provides a durable, robust finish on its own, eliminating the need for a separate topcoat.

The drying time can vary, but it is typically touch-dry within 1-2 hours. Recoating can usually be done after 2-4 hours, depending on humidity and temperature.

Yes, it is suitable for use on kitchen cupboards and other furniture, providing a durable finish.

A 500ml tin covers up to 7m² with a single coat. For a more durable finish with two coats, coverage is approximately 3.5m².

Yes, Frenchic Virgin Trim Paint is EN71-3 certified, making it safe for use on children's toys and furniture.

Clean gently with a soft, damp cloth. Avoid abrasive cleaners or scrubbing pads.

Ensure the surface was thoroughly cleaned and dried before application. Remove any traces of wax or grease. For very glossy surfaces, a light scuffing may improve adhesion.

Stir the paint well before and during use. Apply thin, even coats rather than one thick coat. Use a good quality brush or roller suitable for water-based paints. Allow adequate drying time between coats.

Ensure the paint has been stirred thoroughly. If the environment is very cold, this may thicken the paint slightly. Warming the paint gently (do not heat directly) may help, or consider a very small addition of water if recommended by the manufacturer for specific application methods, but typically it is ready to use.

This can sometimes occur in humid conditions or if the paint was applied too thickly. Ensure adequate ventilation and allow more time for curing. Avoid applying subsequent coats until the previous one is fully dry and non-tacky.