Siramico Coatings One Coat Anti-Slip Floor Paint - Mid Grey

This paint is designed for durable interior floor applications. While it offers protection, prolonged exposure to extreme weather conditions may affect its long-term performance. For exterior surfaces, always consult product recommendations for specific environmental resistance.

The product is formulated for 'One Coat' application, meaning a single coat is typically sufficient for good coverage and durability. However, for very porous surfaces or if a deeper color is desired, a second coat may be applied after the first has dried (1-4 hours at 20°C).

For routine cleaning, use a damp cloth or a soft brush with mild soap and water. Avoid using harsh chemicals or abrasive scouring pads, as these can damage the paint's protective finish.

Yes, the paint is designed to withstand heavy foot traffic and daily use, offering a tough, long-lasting finish suitable for garage floors that experience vehicle movement.

This paint features a non-toxic, VOC-free, and odorless formula, making it safe for use in indoor environments without concerns about harmful emissions.

It is generally recommended to apply over bare, prepared surfaces for optimal adhesion. If applying over an existing finish, ensure it is sound, clean, and lightly abraded (sanded) to provide a key for the new paint to adhere to. Test in an inconspicuous area first.

At 20°C, the paint dries in 1-4 hours. Drying times may be longer in cooler temperatures or humid conditions and faster in warmer, drier environments. Ensure adequate ventilation.

Ensure the surface was properly cleaned and fully dried before application. Remove any grease, oil, or existing coatings that may inhibit adhesion. Consider a light sanding of the surface if it is very smooth or sealed.

Ensure the paint was stirred thoroughly before application. Apply using a consistent technique with a quality brush or roller. Avoid overworking the paint and try to maintain a wet edge when painting large areas.

Drying times can be affected by temperature and humidity. Ensure the application area is within the recommended temperature range (typically above 10°C and below 30°C) and has adequate ventilation. Lower temperatures or high humidity will slow down drying.

The final color can sometimes appear slightly different once fully cured. Ensure you have a consistent application thickness across the entire surface. If a color discrepancy persists, consider a second coat after proper drying.