Ronseal Wet Rot Wood Hardener - Red

The Ronseal Wet Rot Wood Hardener dries in approximately 2 hours.

Yes, it is suitable for most wood types, both interior and exterior.

It is recommended to clean and remove any loose debris. Light sanding may be needed to help the hardener penetrate the wood.

Wash the affected area thoroughly with soap and water. If irritation persists, seek medical advice.

No, you should use wood filler after the hardener has dried to create a smooth surface, then paint.

Apply the hardener liberally to ensure complete saturation of the affected area.

The hardener itself is not waterproof, however, the wood can be further protected with suitable top coat paint or varnish once treated.

Ensure the wood surface is clean and free of paint or varnish. Lightly sand the surface if necessary to improve penetration.

Check the product expiry date. Ensure the ambient temperature is suitable for drying (check product instructions for recommended temperature range).

The red color is designed to identify treated areas. This is usually covered with filler and paint. Apply the filler and paint to match the desired finish.

Ensure the hardener has completely dried before applying the filler. Lightly sand the hardened surface to provide a better key for the filler.